The Challenges to Swim Spa Covers

Swim Spas represent distinct challenges when it concerns covering them.
We can all agree that the swim spa needs to be covered when not in use for all the same factors a hot tub requires a cover. The obstacle is that because of the length of the swim spa and the height of the sides, eliminating and changing the cover can be a lot harder.
Getting a new swim spa is an exciting occasion in life. You’re looking forward to the exercise you’ll obtain from using it. Perhaps you’re a little relieved to have actually lastly made a selection from the various designs you looked at. At any rate, you probably weren’t thinking much about the cover you would use.
Normally, the cover that gets home with your brand-new purchase will be a four area stiff foam filled cover that will divide in the center and go off both ends.
No big deal.
Up until it begins to get heavy.
Which it constantly does.
Every stiff foam filled Swim Spa Cover ever made ends up the same way and it is not the fault of the user. It’s a design defect. Built in obsolescence since as soon as it is put in use over the warm water in your swim spa it is inevitable.
It’s not from rain, so having a taper won’t make any distinction. In fact you could have it under a roof and the cover will still get heavy.
The factor is the steam from the water. The molecules of steam are very small as they rise from the water surface. They make their way into the little fractures and crevices in the foam. Then as the steam cools it forms back into a liquid and becomes trapped in the cover.
It happens slowly and on a Swim Spa Cover which is made from private sections, at differing speeds. So eventually you’ll see one or two of the areas are truly getting heavy. The bar lifters on the ends of the swim spa aren’t much assistance due to the fact that you still have to lift that heavy cover back up onto the spa which is a lot higher than a routine spa.
This is why SpaCap.com developed a various design for their Swim Spa Covers
Instead of using numerous foam panels to construct Swim Spa Covers that will eventually wind up in some land fill, they developed one that uses air chambers that do not suck up wetness.
In fact SpaCap.com Swim Spa Covers are light-weight, insulate better, won’t blow away in a wind storm or be damaged by snow or hail.
Covered with Sunbrella Marine fabric, these covers will not fade, or fall apart at the seams either. So if you own a swim spa, and you intend to keep using it daily, SpaCap.com has the Swim Spa Cover for it.
If you’re not ready to purchase today, bookmark this site so you can discover it once again when you’re ready!

Leave a Reply

Your email address will not be published. Required fields are marked *