The Challenges to Swim Spa Covers

Swim Spas represent special challenges when it pertains to covering them.
We can all concur that the swim spa has to be covered when not in use for all the same factors a hot tub needs a cover. The obstacle is that because of the length of the swim spa and the height of the sides, getting rid of and replacing the cover can be a lot more difficult.
Getting a new swim spa is an interesting occasion in life. You’re eagerly anticipating the exercise you’ll receive from using it. Maybe you’re a little relieved to have finally made a selection from the various models you took a look at. At any rate, you most likely weren’t believing much about the cover you would use.
Typically, the cover that gets back with your new purchase will be a four section rigid foam filled cover that will divide in the center and go off both ends.
No big deal.
Up until it begins to get heavy.
Which it always does.
Every stiff foam filled Swim Spa Cover ever made winds up the same way and it is not the fault of the user. It’s a design defect. Built in obsolescence since as quickly as it is positioned in use over the warm water in your swim spa it is inevitable.
It’s not from rain, so having a taper won’t make any distinction. In fact you might have it under a roof and the cover will still get heavy.
The reason is the steam from the water. The particles of steam are extremely small as they rise from the water surface.

They make their method into the little cracks and crevices in the foam. Then as the steam cools it forms back into a liquid and becomes trapped in the cover.
It happens slowly and on a Swim Spa Cover which is made of private areas, at differing speeds. So eventually you’ll observe a couple of of the sections are really getting heavy. The bar lifters on completions of the swim spa aren’t much assistance since you still need to lift that heavy cover back up onto the spa which is a lot higher than a routine spa.
This is why SpaCap.com created a different design for their Swim Spa Covers
Instead of using a number of foam panels to develop Swim Spa Covers that will ultimately end up in some landfill, they developed one that uses air chambers that don’t suck up moisture.
In fact SpaCap.com Swim Spa Covers are light-weight, insulate much better, will not blow away in a wind storm or be damaged by snow or hail.
Covered with Sunbrella Marine fabric, these covers won’t fade, or break down at the seams either. So if you own a swim spa, and you mean to keep using it everyday, SpaCap.com has the cover for it.
If you’re not ready to purchase today, bookmark this website so you can find it again when you’re all set!

Leave a Reply

Your email address will not be published. Required fields are marked *